|
|
|
|
|
|
Kreg Tool KMA2600 Cutting Guides, Square-Cut
|
|
|
Aligns saw blades to pencil marks and makes 90 degree cuts. Adjustable guide arm compensates for the length from the blade to the edge of base plate. Switch back and forth between any circular or jig saw. Supports workpieces up to 12" wide. Rubber feet ensure secure control. Low-profile design. Built-in roof pitch scale for cutting siding.
|
|
|
|
|
|
|
|
|
|
CLAMP TRACK
|
|
|
These easy-to-use clamps lock into place on the underside of the Accu-Cut? track and starting block to offer additional holding power when needed, such as when working with slick-surfaced sheet goods such as melamine-coated particle board, or when cutting with a single length of track. The clamps are also suitable for use with the Adaptive Cutting System Guide track by sliding them onto the underside of the track where additional holding power may be needed.
|
|
|
|
|
|
|
|
|
|
Johnson True Line J4900 Heavy Duty Cutting Guide, Aluminum
|
|
|
Use with any hand or power tool to produce an accurate, straight cut over long distances. Easy to use connector, extends to 8'2". Includes two ``C" clamps to fasten it to any surface under 3". Half inch high edge may be used as a router guide. The extrusion measures 1/2" x 2-1/2".
|
|
|
|
|
|
|
|
|
|
GUIDE CUTTING PROF 98IN
|
|
|
Heavy-duty aluminum rails for durability extendable to 98". Quick to assemble connector makes it a snap to set up. Can be used with circular saw, jig-saw and utility knife. Includes: (2) rails, (1) joiner plate and (2) C-clamps.
|
|
|
|
|
|
|
|
|
|
TRACK CIRCULAR SAW ALUM 24IN
|
|
|
Makes rip cuts and crosscuts up to 24" wide. Cuts multiple pieces to the same size with just one setup. Eliminates the need for marking, measuring, and layout lines. Universal Sled accepts most circular saws, left or right blade.
|
|
|
|
|
|
|
|
|
|
PACK EXPANSION ACCU-CUT
|
|
|
Transform your Accu-Cut? into a high-performance, 100" track guide with the Accu-Cut Expansion pack. It connects easily to your Accu-Cut to deliver the same straight, accurate, splinter-free performance on cuts up to 100" long. Make the cuts you need at any length and angle on panels, plywood and MDF. The anti-slip, anti-chip guide strips extend through all four track pieces to bring tear-out protection and stability to your cuts, no matter the length.
|
|
|
|
|
|
|
|
|
|
TRACK SAW X-LARGE
|
|
|
Set your projects up for success by making straight, accurate, splinter-free cuts with the Accu-Cut? XL Circular Saw Track Guide. It rips, crosscuts and makes angled cuts up to 100" long in plywood, MDF and other large panels with accuracy and control. The anti-chip guide strips prevent splintering and tear-out through the entire length of your cut. The same strips also feature an anti-slip surface that holds the track in place without clamps.
|
|
|
|
